Welcome to TruFire documentation!

Contents

• Welcome
  • TruFire Printer
    • Disclaimers
• Copyright and Legal
  • Corporate Headquarters
  • All Rights Reserved
  • Disclaimers
• Product Information
• Site Preparation Guide ST
  • Introduction
  • Printer Specifications
    • Printer Dimensions and Weight
    • Printer Dimensions and Weight with unloader
    • Skidded Dimensions and Weight
    • Electrical Requirements
    • Compressed Air Supply Requirements
    • Environmental Requirements
    • Room Requirements
    • Location Requirements
    • Network Requirements
    • Raster Image Processor (RIP) Requirements
    • Safety Requirements
    • Minimum Service Access Requirements
    • Miscellaneous Requirements
• Site Preparation Guide TruFire LT and LT-X2
  • Introduction
  • Printer Specifications
  • Printer Dimensions and Weight
  • Printer Dimensions and Weight with unloader
  • Skidded Dimensions and Weight
  • Electrical requirements
  • Compressed Air Supply Requirements
  • Environmental Requirements
  • Room Requirements
  • Location Requirements
  • Network Requirements
  • Raster Image Processor (RIP) Requirements
  • Safety Requirements
  • Minimum Service Access Requirements
  • Miscellaneous Requirements
• Customer Checklist
  • Electrical Requirements
  • Air Requirements
  • Network/PC/RIP
  • Room/Location Requirements
  • Please provide Digitech with the following information
• Installation Guide
  • Requirements
    • Site of the printer
    • Removing the shipping brackets
    • Leveling the equipment
    • Installing the PPS Computer System
    • Checking electrical and network connections
    • Power up the printer
    • Configuring the Internet Access
    • Testing Network Connectivity
    • Printer Initialization
    • Testing the motion
    • Installling the printheads
    • Filling up the ink buckets
    • Updating the waveform
    • Crossflow the printheads
    • Autogap Calibration
    • Printhead alignments
    • Configuring the RIP
    • TCP IP Printer port
    • Testing the print output
• Daily Start Up Guide
  • Daily Start Up Checklist
  • Power Up
  • Checking Network connections
  • Printer Initialization
  • Motion System
  • Daily Maintenance Requirement
  • Filling the ink buckets
  • Priming the printheads
  • Daily White Procedure
  • Preparing Media for Print
  • Starting Production
• GUI Guide
  • Graphic User Interface
• Color Profiles
  • Color
• Maintenance Guide
  • Daily Maintenance Requirement
    • Daily White Procedure
  • Once a week Maintenance Requirement
    • Changing fans and UV lamps filters
    • Wiping the Ionizer bar
    • Waste Bucket Maintenance
    • Greasing the bearings
    • Changing ink filters
• Printing Thick Media Guide
  • Get started to print thick material
  • Masking the Table
  • Creating a Jig
• Daily White Ink Procedure
  • Technical Bulletin
• Holiday White Ink Procedure Guide
  • Extended Shutdown Procedures during Holidays
• Troubleshooting Guide
  • Disclaimers
• Consumable and Service Parts Guide
• Replacing Parts Guide
  • Head Crash Sensor replacement
  • UV Lamps replacement
• Ink Safety Data Sheet

Note

This project is under active development.